Moin,
soeben auf der Seite von ITP über dieses Exemplar gestolpert. Die Form finde ich durchaus nicht gewöhnlich.
Hier stelle ich Euch schon mal die technischen Daten ein:
Battery installation:
Remove the light tail.
Insert the battery with the negative end toward the tail.
Operation:
Insert the battery and tighten the tail
Tighten the head clockwise to turn on the headlamp.
When the light is on, loosen (counter-clockwise) and tighten (clockwise) the head within 1 second will change the mode
from low, medium to high level.
When choose a specific mode, the headlamp with memorize it and next time the headlamp will enter into that specific
mode when turning on.
Loosen the head to turn off the headlamp.
Warning:
If you don't need to use the headlamp for quite a long time, it is suggested to loosen the tail as well,
which will avoid the unexpected turning on.
Quellennachweis: H01---ITP light electronic Co., Ltd
Grüße
Klondike
soeben auf der Seite von ITP über dieses Exemplar gestolpert. Die Form finde ich durchaus nicht gewöhnlich.
Hier stelle ich Euch schon mal die technischen Daten ein:
- LED Type: Cree XP-E Q5
- Function: Low-Med-High
- Finish: HA Type Ⅲ
- Reflector: Orange Reflector
- Lens:Anti-shattering ultra clear lens, anti-scratching and anti-slip
- Water and Dust Resistant to IP68
- Switch: Head Twisty Switch
- Mil-spec: MIL-STD-810F
- Battery: 1 x AAA, 1 x Rechargeable NiMh AAA, or 1 x 10440 (due to the small body size, 10440 batteries are
not recommended since it may cause the light becoming hot very quickly). - Functions and Runtime
Three output levels: Low 1.5 lumens (50 hours) -> Medium 18 lumens (4 hours) ->-High 80 lumens (55 minutes) - Standard Accessories: 1 x Clip, 2 x O-rings, 1 x Manual
- Size and Weight:
L 52.5mm (2.07'') x D 16.2mm (0.64'') x W 36.2mm (1.43'') ,
22.8g (Excluding Battery and belt), 50.8g (Excluding battery)
Battery installation:
Remove the light tail.
Insert the battery with the negative end toward the tail.
Operation:
Insert the battery and tighten the tail
Tighten the head clockwise to turn on the headlamp.
When the light is on, loosen (counter-clockwise) and tighten (clockwise) the head within 1 second will change the mode
from low, medium to high level.
When choose a specific mode, the headlamp with memorize it and next time the headlamp will enter into that specific
mode when turning on.
Loosen the head to turn off the headlamp.
Warning:
If you don't need to use the headlamp for quite a long time, it is suggested to loosen the tail as well,
which will avoid the unexpected turning on.
Quellennachweis: H01---ITP light electronic Co., Ltd
Grüße
Klondike
Zuletzt bearbeitet von einem Moderator:
Ja, die Lampe sieht in der Tat recht ungewöhnlich aus. Bin mal auf das erste Review gespannt. Vielleicht sogar von mir, denn ich suche noch eine Kopflampe.
Das ist, wie so oft bei iTP, sehr fair.
